| Product Detail: |
 |
Wanda Built-in Module - NWH1023
This IEEE802.11b compliant WLAN radio module is specially designed for embedded system application. This device is built with TI TNET1100B Combo baseband/MAC chip together with Maxim 2820 radio. It has the best radio performance as well as the lowest power consumption.
This RF module is based on CardBus interface but with the
different connector and mechanical form factor. With a proper
adapter board, this RF module can be treated and tested
as a standalone WLAN CardBus adapter. When it is used for
the embedded system application, it can also be used as
a 16 bits slave interface defined by TNET1100B data sheet
for the application such as either PDA as a WLAN client
or an Access Point.
HIGHLIGHTS
Very Low Power Consumption
Supports Adaptive Power Control
Reserved Pin for coexistence of WLAN and Bluetooth
|
| Product Specifications
| Standard Compliance |
IEEE802.11b |
| Host Interface |
32-bit CardBus
PCMCIA 16-bit Slave mode
Compact Flash |
| Antenna Interface |
Two 50 Ohm antenna pads
provided |
| RF Emission Type |
Direct Sequence Spread Spectrum
(DSSS) |
| RF Frequency Band |
2.4GHz |
| RF Output Power |
15 dBm (Typical) |
| Data Rate |
44/22/11/5.5/2/1Mbps with
auto fall back |
| Security |
64/128/256-bit WEP Encryption |
| Power |
Power Supply Voltage: 3.3V±
5%
Power Consumption:
Transmission: 290mA
Receiving: 280mA
Sleep: 10mA |
| Dimension |
46.0 x 28.0 x 3.8 mm (1.81
x 1.10 x 0.15 inch) |
| Weight |
5 g (0.01 lb) |
|
